Skip to Content
This question has been flagged
2 Replies
1403 Views
Avatar
Yuri Kim

So when I flash iotbox.img on my SD card with etcher, I see my SD card is divided into two different drives. One says boot the other one is just drive. 


If I put the flashed SD card in rpi 4b 8gb, it boots without any problems and I can use pos as normal. 


I can access the boot drive on my pc but when I try to access the other drive, it tells me I need to format first. If I just close without formatting, I can't access the drive at all. If I chose to format, I see empty drive and it no longer works on my pi anymore. 


I'm trying to access the drive to configure and customize XML files but I'm stuck... I think the drive I can not access is where all those customizable filed are stored at but ffs I can not figure out what's wrong with it... I tried with different SD card, different usb port, different card reader, even tried with different posbox file that's not the latest... All ended up with same results.... Please help me... I just want to customize my receipt..... 😭 
Avatar
Discard
Avatar
Quentin Lejeune (qle)
Best Answer

Hello,

What do you want to do?

In IoT Box there aren't xml file.


If you want modify some file you can go to the box with SSH.

user: pi

pass: raspberry

write on the box: sudo mount -o remount,rw /

Avatar
Discard
Avatar
Yuri Kim
Author Best Answer

Thank you so much! I managed to figure it out with your answer @Quentin Lejeune

I couldn't pick the answer due to my karma being too low...

Avatar
Discard