連線磅秤

重要

在歐盟會員國,使用磅秤作為整合裝置時,`法律規定需要認證 <https://eur-lex.europa.eu/legal-content/EN/TXT/?uri=uriserv%3AOJ.L_.2014.096.01.0107.01.ENG>`_。

To connect a scale to the IoT system, use a USB cable. In some cases, you may need a serial-to-USB adapter to complete the connection. If the scale is compatible with an IoT system, no additional setup is required; the scale is automatically detected as soon as it is connected. If the scale is not detected, reboot the IoT box or restart the Windows virtual IoT service.

備註

If the scale still does not function, it might not be compatible with the Odoo IoT system. In such cases, a different scale must be used.

將磅秤連線到 IoT 系統後，請在 POS 設定中配置。

其他資料

將 IoT 系統連線到 POS

Ariva S 磅秤

若要讓 Ariva S 系列磅秤(由 Mettler-Toledo, LLC. 製造)與 IoT 系統搭配使用,必須修改特定設定,並且需要專用的 Mettler USB 轉專用 RJ45 纜線。

重要

必須使用官方 Mettler USB 轉 RJ45 纜線(Mettler 零件編號 72256236)。請聯絡 Mettler 或合作夥伴購買正版纜線。此配置**不支援其他**纜線。

To configure the Ariva S scale for IoT system recognition, refer to the Mettler’s Setup Guide for Ariva S series scales and follow these steps:

  1. Hold the >T< button until CONF appears.

  2. 按 >T< 直到出現 GRP 3,然後按 >0< 確認。

  3. At step 3.1, make sure the value is set to 1 (USB Virtual COM ports). Press >T< to cycle through the options.

  4. Press >0< until 3.6 and make sure the value is set to 3 (8217 Mettler-Toledo (WO)).

  5. 按 **>0<**(如有必要可按多次)直到出現 GRP 4。

  6. 按 >T< 直到出現 EXIT。

    重要

    除非有其他需要,否則**不要**進行任何其他變更。

  7. 按 >0<。

  8. 再按一次 >0< 以 SAVE;磅秤將重新啟動。

  9. Reboot the IoT box or restart the Windows virtual IoT service. The scale should then appear as Toledo 8217.