Ir al contenido
Menú
Se marcó esta pregunta
1 Responder
4403 Vistas

I'm trying to create a BOM for an electronics project. I have created some components ( 100k, 4k7 and so on).  On a circuit board these can be located in one or multiple places like R1 (100k) or R2, R3 and R6 (4k7). Since it's the same component i can place multiple times I want a way to tell the BOM where I place the part so that when I print out the BOM I can see the location of the component directly from the BOM.

I'm completely new to odoo and it seems that this is the only feature I can't find (or program?)


Any help is appreciated - it might have been answered before, in that case a link to the solution would be really nice!

Avatar
Descartar
Mejor respuesta

Hi Hans Peter Haastrup-Nielsen

Define the BOM as below

Create operations and workcenters as below

BOM print can be viewed as below

Hope this helps

Avatar
Descartar
Publicaciones relacionadas Respuestas Vistas Actividad
2
jul 24
41
1
feb 24
2600
3
dic 23
1953
1
ene 23
2235
0
abr 21
1893