تخطي للذهاب إلى المحتوى
القائمة
لقد تم الإبلاغ عن هذا السؤال
1 الرد
4432 أدوات العرض

I'm trying to create a BOM for an electronics project. I have created some components ( 100k, 4k7 and so on).  On a circuit board these can be located in one or multiple places like R1 (100k) or R2, R3 and R6 (4k7). Since it's the same component i can place multiple times I want a way to tell the BOM where I place the part so that when I print out the BOM I can see the location of the component directly from the BOM.

I'm completely new to odoo and it seems that this is the only feature I can't find (or program?)


Any help is appreciated - it might have been answered before, in that case a link to the solution would be really nice!

الصورة الرمزية
إهمال
أفضل إجابة

Hi Hans Peter Haastrup-Nielsen

Define the BOM as below

Create operations and workcenters as below

BOM print can be viewed as below

Hope this helps

الصورة الرمزية
إهمال
المنشورات ذات الصلة الردود أدوات العرض النشاط
2
يوليو 24
41
1
فبراير 24
2610
3
ديسمبر 23
1969
1
يناير 23
2264
0
أبريل 21
1897