Error when confirming MO

Question

I have MO of a certain product A. Product A has component B in the BOM. Lot/ Serial numbers were introduced and the manufactured product A and component B are stored in different lot/serial numbers.
during Manufacturing process, system pics component B from Lot 1 and Lot 2 to fullfill the quantity of component B needed to manufacture product A.
When marking the MO as done, system give the error shown below
"Cannot set the done quantity from this stock move, work directly with the move lines."
Op

Sunyah Faisal · Answer

Since you are using the manufacturing module, try out the module: MO and BoM variance whose author is intelliVersal integrated solutions. This module generates a variance analysis report showing the quantity and cost differences between BoM and actual MO.

Lars Aam · Answer

Little uncertain about that error message. But it might indicate that you have not specified in lot consumed in the manufacturing order.   If the picking is an inventory operation, it do not automatic confirm that this is the lot number used.
Normally confirm like this (if you do not use work order): Click on the bars on the right side, and it opens the move lines
bilde [1]
And you specify lot and qty:
bilde [2]

[1] /web/image/53345080-86f9d480/bilde.png?access_token=ee1970f8-3475-4ba5-a24a-f9

Powiązane posty	Odpowiedzi	Widoki
how can i get MFg date in Inventory module? manufacturing	2 sie 25	558
Change in Work Center Productivity Accounting manufacturing	0 lip 25	475
Suddenly MO's from SO's are being generated as confirmed instead of draft ... we need to change the BoM manufacturing	1 lip 25	907
Manufacturing: two products at once from the same materials Rozwiązane manufacturing	1 lip 25	1309
add more than 1 product to work order manufacturing	0 cze 25	621

To pytanie dostało ostrzeżenie

Podoba Ci się ta dyskusja? Dołącz do niej!