Skip to Content
This question has been flagged
5 Replies
3203 Rodiniai
Portretas
Caylon McKellar

Hello,


Fresh install in a demo environment of Odoo 18. No addons installed, no settings changed other than creating warehouse locations and 3 point of sale registers. When closing a POS session, a new one immediately goes into open control. Making it impossible for me to change settings. Is there a new setting that causes this that I can turn off that I'm not seeing, this happens with all 3 registers. Time stamp of POS sessions below.



POS/00016 OPEN : 11/24/2024 23:43:30

                    Close : 11/24/2024 23:48:50

POS/00017 OPEN : 11/24/2024 23:48:50



Thank you for any help.

Portretas
Atmesti
Oliver Eason

I have the same problem. Tried looking at the urban piper but my businesses / branches are not food delivery related so it's not enabled, I can see it but it doesnt have a tick box assumably for the reason mentioned. 

Any other suggestions??

Portretas
Take N Bake for Business Development
Best Answer

Did you find a solution to this problem as I also have one

Portretas
Atmesti
Portretas
Wael Sabanekh
Best Answer

I have the same problem, and can't find any automatic session control open setting, some settings in the POS are not accessible when the POS status is "Opening Control" has anyone found a solution to this ? 


Portretas
Atmesti
Portretas
Caylon McKellar
Autorius Best Answer

That is just a fluff non-answer. The only thing your "Automatic Session Start" brings up is this very odoo post. 

Portretas
Atmesti
Portretas
Rakesh Patel (patr)
Best Answer

1 Some Odoo POS setups automatically open a new session after closing the previous one. This is often due to misconfigured default behavior or an overlooked automation setting.

2 Check for any setting related to Automatic Session Start or similar behavior. This setting might exist as a toggle or default configuration in Odoo 18. ( Disable if found) 

3 If you're testing with multiple browser tabs or devices, one instance might trigger session openings unintentionally
 

Portretas
Atmesti
Portretas
Carlos Hernández (carh)
Best Answer

Hey everyone!

This might be happening because of the time settings in UrbanPiper.

Here's how to check your store closing hours:

Go to "PoS" (Point of Sale) /  Clic "Configuration" / Choose "UrbanPiper" / "Store Timings" / Check the time in the "Ending hour" field. If it's set later than when you actually close the register, it might trigger an automatic reopening.

Hope this does the trick!


Portretas
Atmesti