Ir al contenido
Menú
Se marcó esta pregunta
1 Responder
3599 Vistas

Hi All, 

I have been trying to get Odoo's check printing alignment down and have been running into an issue.  The Odoo "Check Top Margin" setting was working during initial adjustments, but it has stopped working.  Meaning any adjustments, even gross adjustments,  I enter into the check top margin value doesn't  change the top margin of the check's PDF.

after I adjust the Top Check Margin Value I am "unsending" a check, then regenerating the same check number in order to print on plain paper to check for alignment. Again, this was working fine for adjustments, but has stopped. 

Is there a better way to test the print alignment?

How can i force Odoo to regenerate the check with the updated values?

Why would the adjustments stop working?  


Thank you all for the help!

Avatar
Descartar
Autor Mejor respuesta

We were not regenerating the check image which was the problem. 

Avatar
Descartar
Publicaciones relacionadas Respuestas Vistas Actividad
2
nov 20
3088
4
may 24
12553
1
abr 24
3179
0
nov 23
1936
1
sept 23
2041